Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 release

Repair and operation of the car


Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
- Engine
   + Typical procedures of service of engines
   + Procedures of service of the petrol engine
   - Procedures of service of the diesel engine
      Removal, installation, dismantling and assembly of a head of cylinders
      Removal and installation of the inlet pipeline and final collector
      Removal, check of a state and installation of a belt of the GRM drive
      Removal and installation of cogwheels of the GRM drive
      Replacement of a forward epiploon of a cranked shaft and epiploons of a camshaft and TNVD
      Replacement of a back epiploon of a cranked shaft
      Removal and installation of camshafts and pushers of valves
      Removal and installation of the pallet of a case of the engine
      Removal, check of a state and installation of the oil pump
      Removal and installation of the oil cooler
      Removal and installation of a driving disk
+ Cooling systems of the engine, heating of salon and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Electric equipment of the engine
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


99e20293



Replacement of a forward epiploon of a cranked shaft and epiploons of a camshaft and TNVD

Procedure of replacement of these epiploons is identical on condition that the forward epiploon of a cranked shaft and an epiploon of TNVD are established in a cover of cogwheels (see the Section Removal and installation of cogwheels of the GRM drive), and a camshaft epiploon – in a back cover of a belt of the GRM drive (see the Section Removal, installation, dismantling and assembly of a head of cylinders).

 PERFORMANCE ORDER

1. Remove the components closing access to the corresponding epiploon or remove a cover in which the replaced epiploon is established (see the Sections Removal, installation, dismantling and assembly of a head of cylinders and Removal and installation of cogwheels of the GRM drive).
2. In case of replacement of an epiploon at not uncovered, the old epiploon can be taken from its landing nest the special tool, or a screw-driver (address to an illustration). Try not to leave scratches and zadir on a surface of a pin of a shaft or walls of a landing nest, existence of similar defects will lead to fast failure of a new epiploon.
3. In case of replacement of an epiploon at uncovered beat out an epiploon from a cover, having used a screw-driver and a hammer.
4. Smooth out an internal surface of a landing nest. Slightly grease the outer edge of a new epiploon with pure motive oil, in sponges of an epiploon fill universal greasing.
5. Having used a face head of the corresponding size, or a piece of a pipe of suitable diameter as a mandrel, put a new epiploon in the nest (address to an illustration) (the mandrel has to rest only against the firm outer edge of a face surface of an epiploon) on the same depth on which the old was drowned. Make sure of correctness of landing of an epiploon.
6. Establish into place the being removed components (see the Sections Removal, installation, dismantling and assembly of a head of cylinders and Removal and installation of cogwheels of the GRM drive).
7. Start the engine and check it for existence of signs of leak of oil around landing of an epiploon.