Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating of salon and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Electric equipment of the engine
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
- Transmission line
Specifications
Driveshafts and hinges - the general information
Check of a condition of the transmission line
Removal and installation of the driveshaft
Replacement of cardan hinges
Driving shaft / half shafts, - the general information and check of a state
Removal and installation of half shafts, bearings and epiploons of the back bridge
Replacement of an epiploon of the leading gear wheel of differential
Removal and installation of assembly of the back bridge
Removal and installation of power shafts
Replacement of protective covers and service of CV JOINTS
Removal and installation of assembly of forward differential
Removal and installation of naves with the switched-off drive
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of power shafts
Nave of a forward suspension bracket
|
|
1. Weaken wheel nuts, the car and install to a poddomkratta it on props. Remove the corresponding forward wheel.
2. Empty differential (see the Head Nastroyki and routine maintenance of the car).
3. Remove a brake support (see the Head Brake system).
4. Remove a nave (see the Section Removal and installation of naves with the switched-off drive), then take a lock ring and throw off a remote washer (address to an illustration above).
5. Having tapped through a brass drift, weaken landing of a shaft in assembly of a rotary fist.
6. Disconnect from a rotary fist the lower lever of a suspension bracket (see the Head Podvesk and a steering).
7. Take away assembly of a fist outside and release an internal pin of a power shaft from assembly of differential, – in case of need tap a shaft a hammer with soft brisk for weakening of its landing in a lateral gear wheel.
8. Installation is made upside-down. Track reliability of a tightening of a stupichny nut. |
|
|
|
