1. Though independent service To/in is not recommended, it is possible to take some preventive measures for extension of its working capacity.
2. Include once a month To/in to be convinced of greasing of internal components and integrity of consolidations.
3. Watch the cooling system and composition of cooling liquid to avoid freezing of a radiator during the work K/V.
4. Keep clean and integrity the K/V condenser to avoid violation of heat exchange and decrease in efficiency K/V.
5. For collecting and condensate plum at the bottom of the evaporator is provided a drainage tube. Do not allow its contamination to avoid violation of work To/in and pourings of condensate on a floor of salon.
6. For check To/in carry out the following procedures.
7. Regularly examine components of system K/V. Be convinced of lack of leak of coolant, damages of the coupling of the compressor, serviceability of the drive of the compressor, purity of a drainage tube of the evaporator and honeycombs of the condenser, integrity of conducting and its isolation, sockets and safety locks.
8. The leakage of coolant is shown in the form of deposits in a leak place which acquire oily dirt over time.
9. Make sure that the motor of the fan works in all modes. Check an air stream via deflectors.
|
|
Remember that at high humidity efficiency even completely serviceable To/in falls since the thermal capacity of damp air is much less, than dry. |
|
|
