Removal and installation of assembly of a rotary fist with a nave
Remember that the dust developed in the course of operation of brake mechanisms may contain extremely unhealthy the person asbestos. Do not blow off dust compressed air at all and do not inhale it, at service of mechanisms put on a protective mask or a respirator. Do not use for rubbing of components of brake system gasoline or solvents on an oil basis, apply only firm cleaners or methyl alcohol!
Nave of a forward suspension bracket
PERFORMANCE ORDER
1. Cock the parking brake. Weaken nuts of fastening of the corresponding forward wheel, a front of the car and establish to a poddomkratta it on props. Remove a wheel. 2. Disconnect a basic arm of a brake hose and the other lines of communication provided by a complete set from a rotary fist (address to an illustration above). On the equipped ABS models remove from assembly of a fist the wheel sensor (see the Head Brake system). 3. Remove assembly of a nave with a brake disk (see the Head the Transmission line). 5. Remove a bryzgootboynik of a brake disk (see the Head Brake system). 6. Remove an epiploon, laying and a boot (address to an illustration above). 7. Disconnect from a rotary fist a tip of steering draft (see the Section Check of a State, removal and installation of drafts of the steering drive). 8. Poddomkratte the lower lever of a suspension bracket also disconnect it from a rotary fist. 9. Remove the forelock and give a nut. 10. Disconnect a rotary fist from the top lever. 11. Remove a rotary fist from the lower lever. 12. Installation is made upside-down. Track that all fixture was tightened with the demanded effort.
