Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating of salon and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Electric equipment of the engine
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
+ Transmission line
- Brake system
Specifications
System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
Replacement of brake shoes
Removal and installation of supports of disk brake mechanisms
Check of a state, removal and installation of a brake disk
Removal and installation of the main brake cylinder (MBC)
Check of a state and replacement of brake lines and hoses
Sensitive to loading / perepusknoy valve (LSP & BP)
Adjustment of the parking brake
Replacement of cables of the drive of the parking brake
Check of serviceability of functioning / tightness, removal and installation of the amplifier of brakes
Pumping of brake system
Adjustment of a pedal of a foot brake
Check of serviceability of functioning and replacement of the sensor switch of stoplights
Sensors and activator of ABS system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Check of a state and replacement of brake lines and hoses
|
|
1. Approximately time in half a year, having lifted the car, check all flexible hoses connecting steel tubes of hydraulic contours to brake mechanisms of wheels for existence of cracks, signs of damage of a protective cover, traces of leak of liquid, swellings and other damages. Hoses are a critical and most vulnerable component of brake system therefore them it has to be examined with all care – use a pocket small lamp and a small mirror. At identification of any doubtful signs the suspected hose is subject to replacement.
2. When replacing brake lines it is necessary to pay special attention to selection of replaceable components. It is not necessary to install to the hydraulic highway of brake system the copper tubes not capable to sustain the efforts developed in contours at all. Try to get firm steel lines in representative offices of the company manufacturer of the car, it is preferable to buy the sections which are already cut on length and equipped with nipple nozzles. Flexible hoses also have to be the superior quality.
3. At installation of brake lines watch that they passed not less than in 20 mm of the vibrating and moving elements of a suspension bracket and the power unit.
|
|
4. At an otpuskaniye of nuts of nipple sockets of connection of steel lines with flexible hoses use a special cap key with a cutting head (address to an accompanying illustration). |
|
|
5. Having released a nut, take a clamp and release a hose from a basic arm (address to an accompanying illustration). |
6. At a detachment of a flexible hose from a support of the brake mechanism turn out a hollow bolt of the nipple socket and will throw out old sealing washers. At connection of a washer are subject to replacement without fail.
7. At a rassoyedineniye of two hoses use two Rozhkov of a key. Watch that when joining hoses there was no their twisting.
8. For fastening of steel lines the set of intermediate clamps is usually used. The failed clamps are subject to replacement without fail!
9. Watch reliability of fastening of brake lines in all provided intermediate clamps and basic arms.
10. Having finished installation of new sections of hydraulic lines, check liquid level in the GTTs tank. In case of need make the corresponding adjustment. Pump over brake system (see the Section Pumping of Brake System). Before starting operation of the car make sure of serviceability of functioning of brakes. |
|
|
|
