Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating of salon and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Electric equipment of the engine
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
+ Transmission line
- Brake system
Specifications
System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
Replacement of brake shoes
Removal and installation of supports of disk brake mechanisms
Check of a state, removal and installation of a brake disk
Removal and installation of the main brake cylinder (MBC)
Check of a state and replacement of brake lines and hoses
Sensitive to loading / perepusknoy valve (LSP & BP)
Adjustment of the parking brake
Replacement of cables of the drive of the parking brake
Check of serviceability of functioning / tightness, removal and installation of the amplifier of brakes
Pumping of brake system
Adjustment of a pedal of a foot brake
Check of serviceability of functioning and replacement of the sensor switch of stoplights
Sensors and activator of ABS system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of supports of disk brake mechanisms
|
|
Remember that the dust developed in the course of operation of brake mechanisms may contain extremely unhealthy the person asbestos. Do not blow off dust compressed air at all and do not inhale it, at service of mechanisms put on a protective mask or a respirator. Do not use for rubbing of components of brake system gasoline or solvents on an oil basis at all, apply only firm cleaners or methyl alcohol!
|
|
|
Supports of both brake mechanisms of one axis have to change at the same time. Remember that at firm car repair shops Toyota it is always possible to order the restored assemblies of brake supports on an exchange basis.
|
Details of installation of brake supports are presented on illustrations of the Detail of installation of front brake shoes and a support and the Detail of installation of back brake shoes and a support.
|
|
1. Weaken nuts of fastening of forward wheels. A car front also establish to Poddomkratta it on props. Cock a parking brake / prop up antiretractable boots the wheels standing on the earth. Remove wheels.
2. Pump out about 2/3 brake fluids from the GTTs tank, at push-up of pistons level liquid can start being forced out from the tank. Get drain capacity under assembly of the brake mechanism and process a surface of the last a special cleaner. Get drain capacity under assembly of the corresponding brake mechanism and carefully wash out a surface of the last a special cleaner.
|
|
3. Give a cap nipple nut and disconnect the brake line from a support (address to an accompanying illustration). |
|
|
4. Turn out bolts of fastening of a support (address to an accompanying illustration). If the support does not manage to be removed from a brake disk, therefore, blocks cling to the fillet formed on limit of wear of a disk, remove blocks (see the Section Replacement of Brake Shoes). |
5. If the removed support is subject to further use, carefully wash out it in the special cleaning liquid, do not use kerosene and other oil products for washing of components of the brake mechanism at all! Attentively check a condition of a support, in case of need make its replacement.
6. Establish a support on the regular place and tighten fixing bolts with the demanded effort.
7. Connect a brake hose to a support (do not forget to replace sealing washers). Strongly tighten a cap nut of nipple connection.
8. If disconnected a brake hose, pump over the corresponding brake contour (see the Section Pumping of Brake System).
9. Establish to the place of a wheel, lower the car on the earth and tighten wheel nuts with the demanded effort (see the Head Nastroyki and routine maintenance of the car). Before starting operation of the vehicle make sure of serviceability of functioning of brake system. |
|
|
|
