|
4-4-6-razborka-i-sborka-amortizacionnojj-stojjki.html
4.4.6. Dismantling and assembly of an amortization rack
|
NOTE
Replace springs and shock-absorbers only with pairs.
|
Removal
Remove an amortization rack 1.
Establish the KM-6066 2 adaptation on a workbench or to clamp in a vice.
Establish an amortization rack 3 on KM-6066.
Establish the MKM-6068-10 adaptation on MKM-6068.
Establish the MKM-6068 1 adaptation and pull a spring.
Note placement and the ustanovkany provision of knots load of the persistent bearing will not be removed yet.
Remove the persistent bearing (shooter) from a rod of the piston of the shock-absorber.
Unscrew a nut – hold it with the suitable tool.
Remove the top dempfiruyushchy ring and the top persistent bearing with a spring nest.
Remove the persistent shock-absorber from a rod of the piston of the shock-absorber.
Remove a screw spring by means of the MKM-6068 1 adaptation from a basic pipe of an amortization rack.
Installation
Establish a spring on a basic pipe of an amortization rack 3.
Insert a spring with the MKM-6068 1 adaptation into a basic pipe of an amortization rack.
Put on the persistent shock-absorber a piston rod.
Put on the persistent bearing with a spring nest above and the top dempfiruyushchy ring – before define noted ustanovkany situation and an arrangement.
Establish the persistent bearing on a rod of the piston of the shock-absorber, using the suitable tool
Tighten a new nut (shooter) of 50 N · m.
Unclench the adaptation for compression of a spring of MKM-6068 1 and remove from a spring.
|
NOTE
Watch the correct landing of a spring.
|
Remove an amortization rack from the KM-6066 2 adaptation.
Establish an amortization rack.
Check wheel disorder, if necessary adjust.
| 