Repair of Opel Corsa C, from 2000 to 2005 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. Features of a design
8.2. Hinged elements
8.2.1. Removal and installation of a front bumper
8.2.2. Removal and installation of the holder of a forward beam (blow limiter)
8.2.3. Replacement covered
8.2.4. Removal and installation of a protective covering in a wing
8.2.5. Removal and installation of a rear bumper
8.2.6. Removal and installation of a molding of an entrance aperture
8.2.7. Removal and installation of a forward protective level
8.2.8. Removal and water repeller installation
8.2.9. Replacement of additional consolidation of a frame of a roof
8.2.10. Removal and cowl installation
8.2.11. Removal and installation of the lock of a forward door
8.2.12. Removal and installation of the external handle of a forward door
8.2.13. Replacement directing glasses of an elevating window of a forward door
8.2.14. Removal and installation of an internal covering of a forward door
8.2.15. Remove and establish a level of a crack of a window regulator of a forward / back door inside
8.2.16. Removal and installation of a bracket of the lock of a forward door
8.2.17. Removal and installation of consolidation of a forward door
8.2.18. Removal and installation of a back door
8.2.19. Removal and installation of an internal covering of a back door
8.2.20. Removal and installation of consolidation of a back door
8.2.21. Removal and installation of a back folding door
8.2.22. Removal and installation of the lock of a back folding door
8.2.23. Removal and installation of the external handle of a back folding door
8.2.24. Removal and installation of a pneumatic spring of a back folding door
8.2.25. Removal and installation of consolidation of a back folding door
8.2.26. Removal and installation of an internal covering of a back folding door
8.2.27. Removal and installation of consolidation flew down in a back folding door
8.2.28. Replacement of an element of management of the external rear-view mirror regulated from within
8.3. Body glazing
9. Electric equipment schemes
 








99e20293



8-2-1-snyatie-i-ustanovka-perednego-bampera.html

8.2.1. Removal and installation of a front bumper

Removal
Weaken an overlay of an external contour of a forward left and right wheel arch, to unscrew a nut 1.
Slightly extend and fix an overlay of an external contour of a wheel arch.
Weaken the top part of a front bumper, to unscrew the screw 2.
Weaken a protective covering of a wing from the left and right side, unscrew the screw 1 and 3.
Weaken the lower part of a front bumper, dismantle a nasechny rivet 4.
Dismantle a front bumper.
Release a bumper with a side from the directing tire.

Installation
To establish a front bumper.
Fix a bumper in the directing tire.
Fix the lower part of a front bumper, to establish a nasechny rivet.
Fix protective a wing bumper from the left and right side, tighten screws.
Fix the top part of a front bumper, tighten screws.
Fix an overlay of an external contour of a forward left and right wheel arch, tighten nuts.

«on page back
8.2. Hinged elements
on the following page»
8.2.2. Removal and installation of the holder of a forward beam (blow limiter)