|
3-3-8-proverka-pozicionnogo-pereklyuchatelya-rychaga-pereklyucheniya-peredach-af13-ii.html
3.3.8. Check of the item switch of the lever of gear shifting (AF13-II)
Dismantle the holder of the socket of a plait of wires 2.
Unfasten the socket of a plait of wires of the item switch of the lever of gear shifting 1.
Disconnect the socket of a plait of wires of the item switch of the lever of gear shifting.
Establish adaptations KM-962-A 3 with KM-962-10.
Connect to the socket of a plait of wires of the item switch of the lever of gear shifting.
Connect to the accumulator.
Check work and setup of the item switch of the lever of gear shifting.
Include ignition.
Make switching on all transfers.
|
NOTE
For each transfer the light-emitting diodes corresponding to marks in the sliding table (in drawing check in position of the lever "N" is shown) should light up.
|
At work violation
Adjust hummock system of a drive of gear shifting.
Adjust the item switch of the lever of gear shifting.
Check work of an electric part of the item switch of the lever of gear shifting
Dismantle KM-962-A adaptations with KM-962-10.
Disconnect from the socket of a plait of wires of the item switch of the lever of gear shifting 1.
Disconnect from the accumulator.
Switch off ignition.
Build in the holder of the socket of a plait of wires 2.
Tighten the holder of the socket of a plait of wires – 20 N · m.
Attach and fix the socket of a plait of wires of the item switch of the lever of gear shifting.
| 