Repair of Opel Corsa C, from 2000 to 2005 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
7.1. Power supply system
7.2. Lighting system
7.2.1. Check and adjustment of headlights, external lighting, lamp of salon, switch of headlights
7.2.2. Adjustment of fog lights
7.2.3. Removal and installation of headlights
7.2.4. Removal and installation of back fog lights
7.2.5. Replacement of the filament lamp of a driving beam
7.2.6. Replacement of the filament lamp of a passing beam
7.2.7. Replacement of the filament lamp of xenon headlights
7.2.8. амена filament lamps of the index of turn (a xenon headlight)
7.2.9. Removal and installation of a starter of a xenon lamp
7.2.10. Replacement of a lamp driving beam / lamp of lay fires (a xenon headlight)
7.2.11. Replacement of a filament lamp / lamp of illumination of a luggage carrier or luggage compartment
7.2.12. Removal and installation of lighting registration plates / filament lamps
7.2.13. Removal and installation of the switch of a control lamp of the parking brake
7.2.14. Replacement of the forward lamp of salons / filament lamps
7.2.15. Removal and installation of the back lamp of the salon / filament lamp
7.2.16. Removal and lighter / filament lamp installation
7.3. Onboard electric equipment
8. Body
9. Electric equipment schemes
 












7-2-4-snyatie-i-montazh-zadnikh-protivotumannykh-far.html

7.2.4. Removal and installation of back fog lights

Removal
Dismantle a protective covering of a back wheel niche, unscrew a plastic nut of fastening 1.
Unscrew the Torx 3 screw.
Remove a protective covering 3.
Dismantle back fog lights.
Unblock and disconnect the socket of a plait of wires of 2 back fog lights.
Turn off the screw 1.
Remove back fog lights.
Remount or replace the filament lamp.
Turn off the filament lamp with the boss 3 and remove.
Unscrew and remove the filament lamp.

Installation
Establish back fog lights.
Insert back fog lights.
Tighten the screw.
Connect and fix the socket of a plait of wires of back fog lights.
Inspect work of lamps.
Establish a protective covering of a back wheel niche.
Insert a protective covering, tighten a plastic nut of fastening.
Tighten the Torx screw.

«on page back
7.2.3. Removal and installation of headlights
on the following page»
7.2.5. Replacement of the filament lamp of a driving beam