Repair of Opel Corsa C, from 2000 to 2005 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
4.1. General information
4.2. Wheels and tires
4.3. Running gear
4.4. Forward suspension bracket
4.5. Back suspension bracket
4.5.1. Check of an angular gap of knot of the wheel bearing
4.5.2. Removal and installation of the back bridge
4.5.3. Removal and stabilizer installation
4.5.4. Removal and installation of the back shock-absorber
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Electric equipment schemes
 








Выбор рыболовной яхты для морской рыбалки
99e20293



4-5-3-snyatie-i-ustanovka-stabilizatora.html

4.5.3. Removal and stabilizer installation

Removal
Remove 2 back wheels.

NOTE
Mark the provision of rather drum-type nave.

Turn out 2 screws of 1 fastening of the stabilizer on the back bridge.

NOTE
Watch ustanovkany position of fixing screws.

Remove from the back bridge the stabilizer 3.
Wring out from the back bridge an opravka from soft metal 2 the stabilizer on the one hand.
Remove from the back bridge and clean through lateral face the stabilizer.
Remove the buffer 4 from the stabilizer.

Installation
Establish on the back bridge the stabilizer 3.
Push sideways the stabilizer to the back bridge.
Push on the stabilizer the buffer 4.
Press the stabilizer an opravka from soft metal 2 before ustanovkany situation in the back bridge.
Establish the stabilizer with 2 screws and a nut 1 on the back bridge.

NOTE
Watch ustanovkany position of fixing screws. Screws are established from below up on the back bridge.

Tighten 2 new screws 1 moment of 60 N · m + 15 °.
Establish 2 back wheels – 110 N · to m.

NOTE
Observe the provision of marking.

«on page back
4.5.2. Removal and installation of the back bridge
on the following page»
4.5.4. Removal and installation of the back shock-absorber