Repair of Opel Corsa C, from 2000 to 2005 of release.
1. Operation and car maintenance
2. Engine
2.1. Petrol engines Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I
2.2. Mechanical part of petrol engines Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I
2.3. Cooling system
2.3.1. Filling of system of cooling to fill and air removal (Z10XE, Z10XEP)
2.3.2. Replacement of the sensor of temperature of cooling liquid (Z10XE, Z10XEP, without the conditioner)
2.3.3. Removal and installation of the pump of cooling liquid (Z10XE, Z10XEP, with the conditioner)
2.3.4. Removal and thermostat installation with a branch pipe of cooling liquid (Z10XE, Z10XEP, without the conditioner)
2.3.5. Radiator replacement (Z10XE, Z10XEP, with the conditioner)
2.4. Greasing system
2.5. Injection system
2.6. Petrol engines – the general procedures of check
2.7. Mechanical part of the engine
2.8. Verifying and repair operations of components of a mechanical part of the engine
2.9. Cooling system
2.10. System of injection of fuel of petrol engines
2.11. Greasing system
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Electric equipment schemes
 








99e20293



2-3-4-snyatie-i-montazh-termostata-s-patrubkom-okhlazhdayushhejj-zhidkosti.html

2.3.4. Removal and thermostat installation with a branch pipe of cooling liquid (Z10XE, Z10XEP, without the conditioner)

Removal
Open a cowl.
Merge cooling liquid.

NOTE
On option of the ECO model uncover motor office below.

Substitute the reception pallet.
Open a carving stopper of a drain opening (shooter).
Radiator hose above 2 disconnect from a branch pipe of cooling liquid.
Release a collar.
Dismantle a branch pipe of cooling liquid 1.
Turn off 3 bolts of fastening.
Installation
At replacement of details consider various options of a design. Watch correctness of numbers of details.
Clean sealing surfaces of the pump of cooling liquid, a branch pipe of cooling liquid.
Establish a branch pipe of cooling liquid.
Replace consolidation.
Tighten 3 bolts of fastening the moment of 8 N · m.
Establish a radiator hose above.
Fix a collar.
Close a carving stopper of a drain opening of cooling liquid.
To fill system of cooling and remove from it air.

NOTE
On option of the ECO model establish a cover of motor office below.

Close a cowl.

«on page back
2.3.3. Removal and installation of the pump of cooling liquid (Z10XE, Z10XEP, with the conditioner)
on the following page»
2.3.5. Radiator replacement (Z10XE, Z10XEP, with the conditioner)