Repair of Opel Corsa C, from 2000 to 2005 of release.
1. Operation and car maintenance
2. Engine
2.1. Petrol engines Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I
2.2. Mechanical part of petrol engines Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I
2.3. Cooling system
2.3.1. Filling of system of cooling to fill and air removal (Z10XE, Z10XEP)
2.3.2. Replacement of the sensor of temperature of cooling liquid (Z10XE, Z10XEP, without the conditioner)
2.3.3. Removal and installation of the pump of cooling liquid (Z10XE, Z10XEP, with the conditioner)
2.3.4. Removal and thermostat installation with a branch pipe of cooling liquid (Z10XE, Z10XEP, without the conditioner)
2.3.5. Radiator replacement (Z10XE, Z10XEP, with the conditioner)
2.4. Greasing system
2.5. Injection system
2.6. Petrol engines – the general procedures of check
2.7. Mechanical part of the engine
2.8. Verifying and repair operations of components of a mechanical part of the engine
2.9. Cooling system
2.10. System of injection of fuel of petrol engines
2.11. Greasing system
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Electric equipment schemes
 












2-3-1-zapolnenie-sistemy-okhlazhdeniya-zapolnit-i-udalenie-vozdukha-z10xe-z10xep.html

2.3.1. Filling of system of cooling to fill and air removal (Z10XE, Z10XEP)

Check and survey
Antifreeze is intended not only for protection of all system of cooling against freezing, but also for protection of all details washed by liquid for cooling, from corrosion / lime application. Therefore even in the conditions of tropics it is impossible to refuse antifreeze addition.
The important role along with structure of a fuel mix is played also by quality of water. Drinking water, as a rule, corresponds to these requirements. The recycled sea water in a qualitative sense is insufficient.
Damages of the engine can arise also from the antifreezes not allowed to use.
After replacement of a radiator, a head of cylinders or consolidation of a head of cylinders it is impossible to reuse the used cooling liquid.
Open cooling system.
Unscrew a cover of a compensatory tank of cooling liquid.
Fill in cooling liquid in a compensatory tank of cooling liquid to «KALT/COLD» mark.
Wrap a cover of a compensatory tank of cooling liquid.
Start the engine idling, the thermostat will not open yet.

NOTE
Air leaves cooling system during a stage of warming up of the engine.

Stop the engine, let's to it cool down.
Check level of cooling liquid in a compensatory tank of cooling liquid and if necessary add to necessary level.

«on page back
2.3. Cooling system
on the following page»
2.3.2. Replacement of the sensor of temperature of cooling liquid (Z10XE, Z10XEP, without the conditioner)