Repair of Opel Corsa C, from 2000 to 2005 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.2. General procedures of check
6.3. Operations of adjustment and replacement of elements of brake system
6.3.1. Adjustment of lay brake system
6.3.2. Removal and installation of forward brake hoses
6.3.3. Replacement of tubes of brake system
6.3.4. Removal and installation of an overlay of brake shoes of a forward wheel
6.3.5. Removal and installation of a protective casing of a brake of a forward wheel
6.3.6. Replacement of a brake disk of a forward wheel
6.3.7. Removal and installation of a brake board of a back wheel
6.3.8. Removal and installation of brake shoes of a back wheel
6.4. Anti-blocking system (ABS 8.0 and ABS of 8.0 ESP)
7. Onboard electric equipment
8. Body
9. Electric equipment schemes
 








Safety Considerations in Cardan Shaft Balancing 99e20293



6-3-5-snyatie-i-ustanovka-zashhitnogo-kozhukha-tormoza-perednego-kolesa.html

6.3.5. Removal and installation of a protective casing of a brake of a forward wheel

Removal
Remove a forward wheel.
Remove a brake disk.
Unscrew a nut of a shaft of a wheel.
Hold a wheel nave with KM-468-B key.
Disconnect the socket of a plait of wires of the sensor established on a wheel of the car.
Disconnect the module of the bearing of a wheel, having unscrewed 3 bolts of fastening.
Unscrew 3 bolts.
Disconnect the module of the bearing of a wheel with a protective casing from a rotary fist and a wheel shaft.

NOTE
Note adjusting position of the module of the bearing of a wheel and a protective casing.

Remove a protective casing from the module of the bearing of a wheel.

Installation
Attach the module of the bearing of a wheel.
Establish a protective casing on the module of the bearing of a wheel.
Establish мдуль the wheel bearing with a protective casing on a shaft of a wheel and a rotary fist.

NOTE
Note adjusting situation. Wrap 3 new bolts and tighten the moment of 90 N · m tighten on + 30 ° and + 15 °.

NOTE
Clear a carving and establish bolts with fixing structure.

Connect the socket of a plait of wires of the sensor established on a wheel of the car.
Fix a wheel shaft on a wheel nave a new nut, tighten the moment of 150 N · m, turn on on 45 °, then tighten the moment of 250 N · m.
Hold a wheel nave by means of the special KM-468-B tool.
Establish a brake disk.
Establish a forward wheel and tighten the moment of 110 N · m.

«on page back
6.3.4. Removal and installation of an overlay of brake shoes of a forward wheel
on the following page»
6.3.6. Replacement of a brake disk of a forward wheel