3.4.6. Replacement of the external hinge of equal angular speeds

Remove collars of fastening of a protective cover and shift a cover from the hinge on a power shaft.

Carefully clear an internal part of the hinge and remove a spring lock ring from the interior of the hinge.

Fix a power shaft in a vice with soft sponges and an aluminum or copper hammer bring down the hinge from a power shaft.

Remove a spring lock ring, laying and a tarelchaty washer from the end of a power shaft.

Fill the internal hinge in 90 grams of greasing.

Establish on a power shaft a tarelchaty washer, the convex party to the hinge.

Establish on a power shaft a new spring lock ring, fix a shaft in a vice with soft sponges, and an aluminum or copper hammer fill the hinge on a power shaft, thus a lock ring should enter accurately into a flute on hinge inside.

Establish on the hinge a protective cover and fix it collars, a screw-driver raise internal edge of a cover, for alignment of pressure of air under a cover. For fastening of collars application of cпециального of the tool is necessary.

Sponges of the tool establish on corners of a clip of a collar, and in this situation tighten sponges the screw.