|
3-4-3-izmerenie-naklonnogo-zazora-bloka-podshipnika.html
3.4.3. Measurement of an inclined gap of the block of the bearing
|
NOTE
If on the established wheel there is a notable gap, measure it, as shown below.
|
Removal
Remove the corresponding back wheel.
For cars with drum-type brake mechanisms: remove a brake drum.
Attach the special KM-468-B tool to a wheel nave.
Attach the special MKM-571-B tool, to a brake support or a board of the brake mechanism by means of the magnetic holder or an arm.
Establish the sensor, if the special MKM-571-B tool at external edge of a brake disk or the wheel bearing.
Check a gap lifting a little special KM-468-B tool.
Maximum admissible inclined gap: 0,1 mm.
|
NOTE
If this value is exceeded, replace the wheel bearing.
|
Installation
Disconnect the special MKM-571-B tool with an arm or the magnetic holder.
Disconnect the special KM-468-B tool.
For cars with drum-type brake mechanisms: establish a brake drum
Establish a back wheel, tighten bolts of fastening the moment of 110 N · m.
| 