Repair of Opel Corsa C, from 2000 to 2005 of release.
1. Operation and car maintenance
2. Engine
2.1. Petrol engines Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I
2.2. Mechanical part of petrol engines Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I
2.3. Cooling system
2.4. Greasing system
2.5. Injection system
2.6. Petrol engines – the general procedures of check
2.7. Mechanical part of the engine
2.7.1. Removal and flywheel installation (engine of 1,4 l)
2.7.2. Replacement of a back epiploon of a cranked shaft
2.7.3. Replacement of consolidations of cores of valves (the established head of the block of cylinders)
2.7.4. Check of an axial free wheeling of a cranked shaft
2.7.5. Removal and installation of a head of the block of cylinders (engine of 1,4-1,6 l)
2.8. Verifying and repair operations of components of a mechanical part of the engine
2.9. Cooling system
2.10. System of injection of fuel of petrol engines
2.11. Greasing system
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Electric equipment schemes
 








99e20293



2-7-2-zamena-zadnego-salnika-kolenchatogo-vala.html

2.7.2. Replacement of a back epiploon of a cranked shaft

Removal
Remove a flywheel.
Remove a plastic ring a screw-driver.

Removal of a plastic ring: 1–plastic ring; 2–screw-driver

NOTE
Make openings in areas shown in drawing in provisions: 5 h and 7 h as it is the unique areas where behind a sealing ring there are cavities.

Use the suitable tool, such as a pricker to make an opening in a sealing ring

Places for a prodelyvaniye of openings: 1–places for openings; 2–suitable tool

NOTE
Diameter of an opening should not be more than 2 mm. Otherwise, the bolt of the KM adaptation 6624 cannot hold a ring.

Place a pricker at external edge of a sealing ring.
Remove a sealing ring.
Fix the KM special tool 6624 on a sealing ring.
Tighten a bolt.

Epiploon removal: 1–KM special tool 6624; 2–special KM-328-B tools and KM 6624

Attach the special KM-328-B tool to KM 6624.
Remove a sealing ring by means of the special KM-328-B tools and KM 6624.

Installation
Remove the sealant remains from connection of the block of cylinders with the oil pallet (shooters in drawing).
Establish a new sealing ring
Shift a sealing ring on a cranked shaft. Shift before complete and uniform landing in the block of cylinders.

NOTE
Do not press a sealing ring completely.

Establish a sealing ring by means of the KM special tool 6623.

Epiploon installation: 1–KM special tool 6623; 2–fixing bolts; 2–fastening bolt

Tighten 3 bolts for fixing.
Completely press a sealing ring.
Wrap a fastening bolt.
Remove the KM special tool 6623
Unscrew 3 bolts for fixing.
Establish a flywheel.

«on page back
2.7.1. Removal and flywheel installation (engine of 1,4 l)
on the following page»
2.7.3. Replacement of consolidations of cores of valves (the established head of the block of cylinders)