Repair of Opel Corsa C, from 2000 to 2005 of release.
1. Operation and car maintenance
2. Engine
2.1. Petrol engines Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I
2.2. Mechanical part of petrol engines Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I
2.3. Cooling system
2.4. Greasing system
2.5. Injection system
2.6. Petrol engines – the general procedures of check
2.7. Mechanical part of the engine
2.7.1. Removal and flywheel installation (engine of 1,4 l)
2.7.2. Replacement of a back epiploon of a cranked shaft
2.7.3. Replacement of consolidations of cores of valves (the established head of the block of cylinders)
2.7.4. Check of an axial free wheeling of a cranked shaft
2.7.5. Removal and installation of a head of the block of cylinders (engine of 1,4-1,6 l)
2.8. Verifying and repair operations of components of a mechanical part of the engine
2.9. Cooling system
2.10. System of injection of fuel of petrol engines
2.11. Greasing system
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Electric equipment schemes
 








99e20293 купить отопительные печи на дровах в интернет-магазине.



2-7-1-snyatie-i-ustanovka-makhovika-dvigatel-1-4-l.html

2.7.1. Removal and flywheel installation (engine of 1,4 l)

Removal
Remove a transmission.
Remove the block of a casing of coupling.
Disconnect a flywheel.

Flywheel removal: 1–flywheel; 2–special adaptation; 3–fastening bolts

NOTE
The KM special adaptation 6263 remains on the engine.

Block a flywheel by means of the KM special adaptation 652.
Unscrew 6 bolts of fastening.
Check a back epiploon of the crankshaft, a flywheel and a gear wreath of a flywheel on existence of damages or wear, replace in case of need.
Clear contact surfaces of a cranked shaft and a flywheel.

Installation
Establish a flywheel on a cranked shaft.
Block it by means of the KM special adaptation 652.
Clear 6 carvings.
Tighten 6 bolts (3) moment of 35 N · m, tighten on +30 °.

Flywheel installation: 1–flywheel; 2–special adaptation; 3–fastening bolts

NOTE
At installation use new bolts.

Put (red) fixing structure for carvings.
Establish the block of a casing of coupling.
Establish a transmission.

«on page back
2.7. Mechanical part of the engine
on the following page»
2.7.2. Replacement of a back epiploon of a cranked shaft