|
2-1-5-proverka-davleniya-szhatiya-z10xe-z10xep-s-kondicionerom.html
2.1.5. Check of pressure of compression (Z10XE, Z10XEP, with the conditioner)
|
NOTE
The engine should be heated-up (temperature of oil of minute of 80 °C).
|
Check procedure
Open a cowl.
Dismantle the ignition module.
Uncover the ignition module, shift it to the right.
Disconnect the socket of a plait of wires.
Turn off 2 bolts of fastening.
Take out a cover by means of the KM-6009 1 adaptation.
|
NOTE
Do not warp the provision of a cover.
|
Dismantle spark plugs.
Unscrew 3 candles by means of the KM-194-E adaptation.
Dismantle the relay of the fuel pump.
Uncover the block of safety locks.
Take out the relay of the fuel pump (shooter).
Check pressure of compression.
|
NOTE
For this procedure it is necessary to involve two people.
|
Press an accelerator pedal.
Hold the provision of full loading.
Start the engine (approximately on 4 c).
|
NOTE
The number of turns of the engine should be not less than 300 mines-1.
|
Compare values of pressure of compression.
Maximum difference of pressure of 100 kPas (1 bar).
Establish the relay of the fuel pump.
Establish into place a cover of the block of safety locks.
Establish spark plugs.
By means of KM-194-E tighten 3 candles with the moment of 25 N · m.
Establish the ignition module.
Tighten 2 bolts of fastening with the moment of 8 N · m.
Connect the socket of a plait of wires.
Establish a cover of the module of ignition.
Close a cowl.
| 