Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 release

Repair and operation of the car

Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating of salon and air conditioning
- Power supply system and production of the fulfilled gases
   Specifications
   Dropping pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a state and replacement of fuel lines and their nipple connections
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - general information
   Removal and installation of the fuel pump
   Replacement of the sensor of fuel consumption
   Removal and installation of assembly of the air cleaner
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of electronic injection
   Check of a state and replacement of components of system of injection
   System of release - the general information
   Removal and installation of nozzles
+ Electric equipment of the engine
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of the fuel pump

See preventions at the beginning of the Section Dropping Pressure in a power supply system.

The components which are subject to removal for access to the fuel pump

Details of installation of assembly of the fuel pump / sensor of fuel consumption

Removal

PERFORMANCE ORDER

1. Dump pressure in a power supply system (see the Section Dropping Pressure in a power supply system).
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for input of the audio system in action!

3. For access to the pump in salon, under a back rug, there is a removable cover (address to an illustration above).
4. Remove back seats, having turned out their fixing bolts, previously having uncovered with them.
5. Remove an overlay of a threshold, a lateral slip and an overlay of a step. Then remove carpets.
6. Uncover the technological hatch.

7. Disconnect fuel lines from a pump arm, previously having removed from them dirt (address to an accompanying illustration).

8. Give eight screws and carefully take assembly of the pump with the fuel consumption sensor from a gasoline tank (address to an accompanying illustration). Laying can be thrown out – for installation it will be required new.

Try not to bend a sensor float leg.

9. Release the lower section of pump assembly from a basic arm (address to an illustration of the Detail of installation of assembly of the fuel pump / sensor of fuel consumption). Disconnect an electrical wiring from assembly of the fuel pump / sensor of fuel consumption and remove a fuel hose.
10. Remove rubber consolidation and a lock ring of fastening of the mesh filter of a toplivozabornik.
11. Remove the mesh filter and estimate extent of its pollution, in case of need make replacement.

Installation

PERFORMANCE ORDER

Installation is made upside-down. Do not forget to replace sealing laying of a landing flange, at the corresponding complete set replace both sealing washers of a hollow bolt of the nipple socket. Tighten fixture with the demanded effort.