Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 release

Repair and operation of the car

Removal and installation of panels of an internal upholstery of doors

In order to avoid receiving cuts of hands about edges of technological windows in a doorframe work in gloves!

Removal

PERFORMANCE ORDER

1. On the models equipped with the electric drive of window regulators, disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for input of the audio system in action!

2. On models with the manual drive of window regulators remove the regulator handle (address to an accompanying illustration), for an otpuskaniye of a ring clamp get edge of rags between the handle and the door panel (it is alternatively possible to use a suitable hook).

3. Remove a door armrest, if necessary having removed plastic caps. At the corresponding complete set remove the handle of management of a door mirror, remove an internal overlay of fastening of a door mirror.

4a. Turn out the screw. remove assembly of the internal handle, having shifted it forward (address to an accompanying illustration).

4b. Remove assembly of the internal handle, having shifted it forward (address to an accompanying illustration).

5. On the models equipped with electrodriving window regulators / activators of the uniform lock accurately having hooked, release the panel of the operating switches from a door armrest. Disconnect an electrical wiring from the panel.

6. On the majority of modifications of the considered models one of screws of fastening of the panel of an internal upholstery of a door is under a support of a rear-view mirror. One more screw is located or is slightly lower, or in a back top corner of the panel (address to an accompanying illustration). Bolts are under plastic caps.

7a. On some models it is necessary to remove the decorative panel of finishing of a support of a door mirror (see the Section Removal and installation of external rear-view mirrors). For office of the panel of an internal upholstery of a door release the clamps located on its perimeter (address to an illustration to paragraph 6), hooking edges of the panel.

7b. For fastening of panels of an upholstery of back doors two lateral clamps, two screws and seven more clamps located along the outer edge of the panel are used (address to an accompanying illustration).

8. Carefully separate a polyethylene moisture protective film, having released two plugs through passage (address to an accompanying illustration).

Installation

PERFORMANCE ORDER

1. Track correctness of installation of the moisture filter. In case of need restore integrity of the torn screen by means of an adhesive tape. In case of need use silicone sealant for a podkleivaniye of edges of the screen. Install into place plugs the through passage, clamps and other fasteners which dropped out in the course of dismantle of an upholstery.
2. Start the panel of an internal upholstery of a door on the regular place and accurately latch all provided clamps. Where it is required, screw fixing screws.
3. Further installation is made upside-down.