2.1.4. Check of phases of a gazoraspredeleniye (Z10XE, Z10XEP, without the conditioner)

Open a cowl

Disconnect plugs of the storage battery

NOTE On cars since a year of release 04 with ESP – after each detachment of the accumulator the sensor of an angle of rotation of a steering wheel loses the main installation. It it is necessary откалибровать anew.

Disconnect a weight wire.

Disconnect 4 sockets of a plait of wires of a control system of the engine: the relay of pressure of oil 2, the sensor of temperature of cooling liquid 3, the sensor of a camshaft 4, the module of ignition 1.

Release the channel for a plait of wires 5.

Plait of wires put aside.

Dismantle the ignition module.

Uncover the ignition module, shift it to the right.

Turn off 2 bolts of fastening.

Take out a cover by means of the KM-6009 adaptation.

NOTE Do not warp the provision of a cover.

Uncover heads of cylinders.

Dismantle 2 hoses of ventilation of a case of the engine.

Turn off 13 bolts of fastening of fastening.

Lift the car.

On the ECO model uncover the engine below.

Remove a carving stopper of a support of a cranked shaft 1.

Lower the car.

Establish the provision VMT of ignition of the cylinder 1.

Insert the KM-952 2 adaptation.

Cranked shaft evenly turn until the KM-952 adaptation will be grasped.

NOTE The mark in a belt pulley of a cranked shaft 4 should be on one line with a lug 3 on the GRM case.

Insert the KM-9531 adaptation, it should enter into a groove of camshafts.

NOTE If it is impossible to insert the KM-953 adaptation, it is necessary to execute the main adjustment of phases of a gazoraspredeleniye.

Establish the KM-9541 adaptation. Get on a disk of the phase sensor 2.

NOTE KM-954 should enter into a groove of a disk of the phase sensor.

Take out fixing tools.

NOTE Fixing tools cannot be used for keeping.

Lift the car.

Establish a carving stopper of a support of a cranked shaft.

Replace a sealing ring.

Tighten a bolt the moment of 50 N · m.

Lower the car.

On the ECO model establish an engine cover below.

Clean sealing surfaces of a head of cylinders and a cover of a head of cylinders.

Establish a cover of a head of cylinders 1.

Replace consolidation 2 and a sealing ring.

Put hermetic (distance of 1-2 mm).

NOTE Installation works are necessary for finishing within 10 minutes.

Tighten 13 bolts of fastening the moment of 8 N · m.

Establish 2 hoses of ventilation of a case of the engine.

Establish the ignition module.

Turn off 2 KM-6009 adaptations.

Tighten 2 bolts of fastening with the moment of 8 N · m.

Establish a plait of wires of a control system of the engine.

Lay a plait of wires.

Fix the channel for a plait of wires.

Connect 4 sockets of a plait of wires.

Connect plugs of the storage battery.

Program volatile memory.

Close a cowl.