Repair of Opel Corsa C, from 2000 to 2005 of release.
1. Operation and car maintenance
2. Engine
2.1. Petrol engines Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I
2.1.1. Engine number
2.1.2. Check of pressure of oil (Z10XE, Z10XEP)
2.1.3. Check of a compression of the engine (Z10XE, Z10XEP)
2.1.4. Check of phases of a gazoraspredeleniye (Z10XE, Z10XEP, without the conditioner)
2.1.5. Check of pressure of compression (Z10XE, Z10XEP, with the conditioner)
2.1.6. Check of pressure of fuel (Z10XE, Z10XEP, with the conditioner)
2.2. Mechanical part of petrol engines Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I
2.3. Cooling system
2.4. Greasing system
2.5. Injection system
2.6. Petrol engines – the general procedures of check
2.7. Mechanical part of the engine
2.8. Verifying and repair operations of components of a mechanical part of the engine
2.9. Cooling system
2.10. System of injection of fuel of petrol engines
2.11. Greasing system
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Electric equipment schemes
 












2-1-2-proverka-davleniya-masla-z10xe-z10xep.html

2.1.2. Check of pressure of oil (Z10XE, Z10XEP)

NOTE
Before carrying out procedure of check the engine should be heated-up (temperature of oil of minute 80°С).

Check procedure
Open a cowl.
Remove the relay of pressure of oil.
Disconnect the socket of a plait of wires.
Substitute the reception pallet.
Establish the special KM-498-B adaptation.
Check pressure of oil of the engine.
Start the engine.
Pressure of oil of the engine should be about 150 kPas (1,5 bar) on idling turns.
Stop the engine.
Remove the special KM-498-B adaptation.
Establish the relay of pressure of oil on a head of cylinders and tighten the moment of an inhaling of 20 N · m.
Replace a sealing ring. Connect the socket of a plait of wires.
Check and if necessary modify level of engine oil.
Close a cowl.

«on page back
2.1.1. Engine number
on the following page»
2.1.3. Check of a compression of the engine (Z10XE, Z10XEP)