Repair of Opel Corsa C, from 2000 to 2005 of release.
1. Operation and car maintenance
2. Engine
2.1. Petrol engines Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I
2.2. Mechanical part of petrol engines Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I
2.3. Cooling system
2.4. Greasing system
2.5. Injection system
2.6. Petrol engines – the general procedures of check
2.7. Mechanical part of the engine
2.8. Verifying and repair operations of components of a mechanical part of the engine
2.8.1. Gap check in a rod the bearing
2.8.2. Gap check in a rod the bearing
2.8.3. Replacement of the shatunny bearing
2.8.4. Replacement of piston rings
2.8.5. Piston replacement with a rod
2.9. Cooling system
2.10. System of injection of fuel of petrol engines
2.11. Greasing system
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Electric equipment schemes
 








escortes 99e20293



2-8-1-proverka-zazora-v-shatunnom-podshipnike.html

2.8.1. Gap check in a rod the bearing

Measurement
Establish a cover of the shatunny bearing (3) with loose leaves of the shatunny bearing (2) on a rod.

NOTE
Do not change a cover of the shatunny bearing and a rod during installation, and provide purity of contacting surfaces

NOTE
Old bolts can be reused for check.

Tighten 2 bolts the moment of 13 N · m, then tighten on +60 ° +15 °.
Diameter of a rod of the center is measured with an internal micrometer in positions I, II, and arithmetically. Formula and example of calculation of diameter of the shatunny bearing: I + II + III.
I–43, 026 mm.
II – 43, 027 mm.
III – 43, 031 mm.
129,084 mm: 3= 43,028 mm.
Average internal diameter of the shatunny bearing – 43,028 mm.
Diameter of a neck of a shaft of the shatunny bearing is measured by an external micrometer in positions I, and II. A formula and an example for calculation of diameter of a neck of a shaft of the shatunny bearing:
I + II/2;
I–42,977 mm + II – 42,985 mm.
85,962 mm: 2= 42,981 mm.
Average diameter of a neck of a shaft of the shatunny bearing – 42,981 mm.
Define a gap in a rod the bearing, using average internal diameter of the shatunny bearing and average diameter of a neck of a shaft of the shatunny bearing.
Average internal diameter of the shatunny bearing: 4,028 mm.
Average diameter of a neck of a shaft of the shatunny bearing: 2,981 mm.
Gap in a rod the bearing: 0,047 mm
The settlement gap in a rod the bearing is equal 0,047 mm in this example. The admissible gap of the shatunny bearing is equal from 0,013 mm to 0,061 mm.

«on page back
2.8. Verifying and repair operations of components of a mechanical part of the engine
on the following page»
2.8.2. Gap check in a rod the bearing