1.6.3. Conditioner

Cooling

The mode of cooling is possible only at the working engine and included обдуве. The mode joins and disconnected by a key the central air located on the control panel.

The signaling device of control of inclusion is built in in the switch.

At the included cooling (the conditioner compressor) air is cooled and drained. If in cooling or drainage of need is not present, follows switch off cooling for economy of fuel.

At low external temperatures cooling is automatically switched off.

By means of the air circulation switch the conditioner is switched in a circulation mode (an inclusion signaling device).

At smoke or smell penetration outside: for short time include air circulation system.

The included system of air circulation reduces air exchange. Humidity of air increases, probably zapotevany glasses. Quality of air in salon worsens over time, it can lead to the fatigue phenomena at passengers.

The system of air circulation is automatically switched off for acceleration of removal of moisture from glasses.

Change of provision of regulators of temperature reaches comfortable ventilation of the top space of salon. If the regulator of temperature is on the average a range: from averages snuffled обдува more cool air arrives, than from the lateral snuffled обдува.

By means of vertical and horizontal moving lamely establish the direction of a stream of air.

To close nozzles, move a latch to the car middle.

For strengthening of an air flow to switch having blown on higher step.

Via the distributor air goes on a windscreen and lateral glasses.

Additional nozzles are located under a windscreen and lateral glasses, and also in front in the bottom space.